Vanquish Hurtz Shifter 3 Pos. Dig.

Version 1.0, Aktion solange Vorrat


This is an optional Vanquish Products Hurtz Shifter 3 Position Dig Unit, and is intended for use with the Axial AX10 Scorpion.

Bitte beachten, keine Ersatzteile verfügbar.

Features:

Dig unit designed as a heavy duty unit for demanding drivers.
Designed to eliminate known flaws that cause failure.
ALL drive dogs are 440c stainless steel, including stationary dogs mounted to the housing.
Sliding mechanisms will not show galling, so only a small amount grease is needed.
Stationary rear drive output does not slide in and out of housing.
Weighs in at 80 grams or .180 lbs.
Servo mount is located on the dig housing so most servo flex is eliminated.
Hurtz Shifter lever action give a mechanical advantage for the servo of 2.5 to 1 ratio. allowing a standard servo to man handle the shifting demands needed in competition crawling.
Total shifter travel needed to shift to all three positions is .73 inches.
** Regular servo mount can use a HITEC HS-5625MG, HS-645MG, or Futaba S3305.
** Can use a HITEC HS-2258MG with optional MiniMount.