Karosserie No-Prep Dragracing 1:10
This project was born from the desire to create an extraordinary product developed specifically for drag races, "No Prep Street Outlaw" and "No Prep Street 13.5 stock" categories.
The body shell was designed on AE DR10 chassis but can also be mounted on Losi 22S chassis No Prep Drag, Traxxas Slash* 2wd Drag Car & Traxxas Drag Slash 1/10.
Made with high quality and genuine polycarbonate Lexan®, 1mm thick
Included in the kit is a complete set of screws, nuts and washers necessary for correct fixing of the additional parts
The additional front splitter, exhaust pipes and rear wing are also supplied with the body shell
Specs: length 640mm, width 280mm, height 164mm
Sold clear with protective film outside
Included in the package a decal sheet pre-cut and the windows mask
* for installation on SlashT 2wd chassis it is necessary to purchase the following Traxxas codes to modify your model and make it suitable for the body shell: # 2531X, # 3636, # 2750R, # 2432, # 2444, # 2437, # 3740, # 2445, # 2443, shortened rear drive shafts and remove the front bumper
Accessories that make the difference!
During the design we have thought of every possible detail and this has led us to produce a variety of parts that complete the racing and realistic look of the ZL21 and aid in performance.
These accessories are INCLUDED together with the body:
Rear wing (extension) to improve and "clean" the air turbulence generated in the rear
Exhausts to give a real look, 'option 1' is a set of zoomie style pipes (4 tubes) or 'option 2' is a turbo style exhaust (single pipe) you will choose which one to mount based on your preference
Front splitter to create a more aggressive appearance, as well as help increase front end stability
Two different exhausts options
Not only we decided to design a cool accessory like the exhausts tubes but we offer you a few different styles all included into the body kit!
Step 1: decide, first of all, if mount on your new ZL21 body shell the single big tube rather than the 4 tubes in line with smaller section
Step 2: cut out with quality scissors (see here) the plates with the style of exhausts that you prefer
Step 3: cut out the hole (marked on the side left/right) on the body, longer if you wanna install the 4 tubes, short hole if you decided to apply the single exhausts tube
Step 4: apply a double side tape over the exhausts plate and press it inside the body
Step 5: enjoy the racing and realistic look!
After having painted the exhausts of your preference, in about 10 minutes you will easily install this nice looking detail to the ZL21 body simply by following the steps indicated above.