Français (CH)
ERSATZTEIL-FINDER

Véhicules RC

Vous trouverez ici une vaste sélection de modèles de véhicules RC. En tant que spécialistes de nos propres pistes de course de voitures RC, nous avons tout pour les débutants et les professionnels.

Trier par:
Recommandé
Montrer:
48
Gear box hight adaptor/spacer for YZ-4SF2
YOK-S4-302H2A
entspricht: S4-302H2
CHF 11.90
En stock
+ −
Aluminum center mount for YZ-4SF2
YOK-S4-304CM2A
entspricht: S4-304CM2
CHF 23.50
En stock
+ −
Graphite center mount plate for YZ-4SF2
YOK-S4-304CP2A
entspricht: S4-304CP2
CHF 11.90
En stock
+ −
Center bone(65mm) for YZ-4SF2
YOK-S4-010B65A
entspricht: S4-010B65
CHF 10.50
En stock
+ −
Center bone(98mm) for YZ-4SF2
YOK-S4-010B98A
entspricht: S4-010B98
CHF 11.90
En stock
+ −
Center drive cup for YZ-4SF2
YOK-S4-010CDA
entspricht: S4-010CD
CHF 10.90
En stock
+ −
Slipper adjust nut / adjust spring for YZ-4SF2
YOK-S4-303AJ2A
entspricht: S4-303AJ2
CHF 9.50
En stock
+ −
Slipper main drive shaft for YZ-4SF2
YOK-S4-303MS2A
entspricht: S4-303MS2
CHF 14.50
En stock
+ −
Slipper plate (for S4-303MS2) for YZ-4SF2
YOK-S4-303P2A
entspricht: S4-303P2
CHF 9.50
En stock
+ −
Gear diff maintenance kit for YZ-4SF2
YOK-S4-500GM
CHF 8.90
En stock
+ −
Graphite front shock tower for YZ-4SF2
YOK-S4-017-1PA
entspricht: S4-017-1P
CHF 19.90
En stock
+ −
Rod end ball coller (offset1) for YZ-4SF2
YOK-S4-206C1A
entspricht: S4-206C1
CHF 18.90
En stock
+ −
Aluminum rear sus mount (Front side/1°wide) YZ4SF2
YOK-S4-300RF1A
entspricht: S4-300RF1
CHF 23.90
En stock
+ −
Rear hub carrier/Bushing (F3mm pin) for YZ-4SF2
YOK-S4-415RA
entspricht: S4-415R
CHF 11.90
En stock
+ −
Rear“X30”shock shaft
YOK-S4-S2LA
entspricht: S4-S2L
CHF 9.50
En stock
+ −
Front“X30”shock shaft
YOK-S4-S2SA
entspricht: S4-S2S
CHF 9.50
En stock
+ −
“X30”shock coller (2 each)
YOK-S4-S4CA
entspricht: S4-S4C
CHF 7.90
En stock
+ −
Caster Angle Spacer
YOK-SD-008SA
entspricht: SD-008S
CHF 1.90
En stock
+ −
RTC Aluminum steering block for BD10/9
YOK-B10-RTC-4A
entspricht: B10-RTC-4
CHF 29.90
En stock
+ −
F5.0
YOK-ZC-S550A
Used for rear axle of YZ-4SF2. 0.5mm thick shim. Containing 8 pieces
CHF 2.50
En stock
+ −
Kugellager Flansch 3x6x2.5mm 2stk.
YOK-BB-63F-2A
entspricht: BB-63F-2
CHF 7.90
Teflon suspension arm spacer F3×F6×1.0?
YOK-ZC-T3610A
entspricht: ZC-T3610
CHF 8.90
En stock
+ −
Curved Slide Rack Servo Mount for YD-2 series
YOK-Y2-202SMA
entspricht: Y2-202SM
CHF 25.90
En stock
+ −
BD10F Stabilisator hinten
YOK-B10-412SWA
entspricht: B10-412SW
CHF 21.00
ZAHNRAD SET
AC7230
CHF 7.90
Hard plastic bevel gear set YD-2/YZ-2/YZ-4
YOK-Y2-503GPHA
entspricht: Y2-503GPH
CHF 15.90
Progressive front shock spring 2.50-3.00
YOK-B10-SSP25A
By changing the pitch of the winding, it is a progressive spring that can suppress excessive roll while giving initial softness. It is mainly used for the front suspension of 4WD touring cars, and it is possible to improve the stability of steering when driving in a layout with a high...
CHF 12.50
69T 3hole Spur gear (Slipper/Direct)
YOK-Z2-SG69SDA
entspricht: Z2-SG69SDA
CHF 6.90
En stock
+ −
Racing Tool 2.0mm Allen Driver black
YOK-YT-20RTBA
entspricht: YT-20RTB
CHF 6.90
En stock
+ −
f10×f15mm Ball Bearing
YOK-BB-1510A
entspricht: BB-1510
CHF 8.50
En stock
+ −
Inner Sponge
YOK-BM-T16A
entspricht: BM-T16
CHF 7.10
En stock
+ −
Aluminum Wing Stay(Low)Black for Drift
YOK-D-057LA
entspricht: D-057L
CHF 12.90
En stock
+ −
Tire Mounting Tape for DRA/DRC Tire
YOK-ZR-DRTA
entspricht: ZR-DRT
CHF 4.90
En stock
+ −
Rear upper arm mount / roll bar holder / gearbox
YOK-Z2-300R31A
Rear upper arm mount / roll bar holder / gearbox support for YZ-2 DTM3.1 / CAL3.1
CHF 12.90
En stock
+ −
Aluminum front lower suspension mount for YZ-2DTM3
YOK-Z2-300FLAA
YZ-2DTM3.1 Standard parts aluminum front lower suspension mount. By swapping the front and back, the height of the suspin can be changed by 1 mm, and the roll center can be adjusted.
CHF 29.50
En stock
+ −
Body Mount Patch (5mm)
YOK-ZR-BMP5B
It is a patch that is attached to the back side of the body of the body mount hole to reinforce the mount hole and protect the paint. For body posts with a diameter of 5 mm.
CHF 6.90
En stock
+ −
Front steering block for YD-2 series
YOK-Y2-415S2A
Resin steering block for RWD drift car YD-2 series. It has been updated for the new short suspension arm, and by installing the steering stopper in the tie rod mounting hole closest to the axle, the optimum turning angle can be obtained.
CHF 7.90
En stock
+ −
BL-EP6 Brushless speed controller (programmer incl
YOK-BL-EP6A
It is a brushless speed controller that comes with a programmer and realizes a reasonable price while supporting each category of on, off, and drift. In addition to Yokomo's sensor-type brushless motors, it is also possible to drive general-purpose sensorless motors. Of course, it is recommended...
CHF 45.00
En stock
+ −
High Grade O-ring for Shock 8stk.
YOK-YS-7HGCA
(oil resistant / with poly slider / 8 pcs) This new type of O-ring provides the best performance as an oil seal for damper shafts. The soft material allows the shock shaft to slide easily, and the extremely oil-resistant silicon rubber material allows the O-ring to maintain its shape...
CHF 9.90
En stock
+ −
Aluminum upper deck adapter for YD-2ZX (rear)
YOK-Y2-003ZARA
entspricht: Y2-003ZAR
CHF 15.90
En stock
+ −
Aluminum Servo Mount for YD-2ZX (Purple)
YOK-Y2-203ZPA
Aluminum servo mount for YD-2ZX. It is compatible with low profile servos and has a height of approximately 17 mm. The color is purple and comes in 2 pieces.
CHF 32.50
En stock
+ −
Special motor mount for YD-2Z series (purple)
YOK-Y2-304ZSPA
Special motor mount for YD-2Z series. The aluminum heat sink shape has a high cooling effect and efficiently cools the motor during drift driving, which tends to heat up. By rotating around the top shaft, the YD-2Z can select the motor position from 13 places depending on the chassis...
CHF 34.90
En stock
+ −
PULLEY FRONT (ONE-WAY - MR-4TC BD)
Z-BD-643
CHF 5.00
KUGEL ALU WORKS'95 8ST
ZC0401L
CHF 14.00
Graphite front bumper brace BD11
YOK-B11-001GA
entspricht: B11-001G
CHF 27.90
En stock
+ −
Graphite upper deck BD11
YOK-B11-003A
entspricht: B11-003
CHF 32.90
En stock
+ −
Graphite front stiffener plate BD11
YOK-B11-003SPA
entspricht: B11-003SP
CHF 17.90
En stock
+ −
Suspension parts set BD11
YOK-B11-008A
entspricht: B11-008
CHF 9.90
En stock
+ −
Catégories
Véhicules RC
Voitures RC
Moto RC
Machines de construction et tracteurs RC
Camions RC
Chars RC
Accessoires et pièces détachées
Avions RC
rc-hélicoptère multicopter
bateaux RC
Elektronik und Akku
Autorennbahn
Plastikbausatz
Sammler-Modell
Spielwaren
Werkstoffe, Werkzeuge, Farben
Gutscheine
Restposten
restpo
Portofreie Lieferung

Online-Bestellungen portofrei ab CHF 80.-

Bestellung auf Rechnung

Einfach auf Rechnung bestellen.

Schnelle Abwicklung

Vor 16.00 Uhr bestellt, Versand per A-Post gleichentags