Deutsch (CH)
ERSATZTEIL-FINDER

Zubehör und Ersatzteile

In unserem riesigen Ersatzteil-Sortiment finden Sie garantiert das richtige Ersatzteil für Ihr RC-Fahrzeug.
Ordnen nach:
Empfohlen
Zeigen:
48
Front steering block for YD-2 series
YOK-Y2-415S2A
Resin steering block for RWD drift car YD-2 series. It has been updated for the new short suspension arm, and by installing the steering stopper in the tie rod mounting hole closest to the axle, the optimum turning angle can be obtained.
CHF 7.90
Auf Lager
+ −
BL-EP6 Brushless speed controller (programmer incl
YOK-BL-EP6A
It is a brushless speed controller that comes with a programmer and realizes a reasonable price while supporting each category of on, off, and drift. In addition to Yokomo's sensor-type brushless motors, it is also possible to drive general-purpose sensorless motors. Of course, it is recommended...
CHF 45.00
Auf Lager
+ −
Aluminum upper deck adapter for YD-2ZX (rear)
YOK-Y2-003ZARA
entspricht: Y2-003ZAR
CHF 15.90
Auf Lager
+ −
Aluminum Servo Mount for YD-2ZX (Purple)
YOK-Y2-203ZPA
Aluminum servo mount for YD-2ZX. It is compatible with low profile servos and has a height of approximately 17 mm. The color is purple and comes in 2 pieces.
CHF 32.50
Auf Lager
+ −
Special motor mount for YD-2Z series (purple)
YOK-Y2-304ZSPA
Special motor mount for YD-2Z series. The aluminum heat sink shape has a high cooling effect and efficiently cools the motor during drift driving, which tends to heat up. By rotating around the top shaft, the YD-2Z can select the motor position from 13 places depending on the chassis...
CHF 34.90
Auf Lager
+ −
PULLEY FRONT (ONE-WAY - MR-4TC BD)
Z-BD-643
CHF 5.00
KUGEL ALU WORKS'95 8ST
ZC0401L
CHF 14.00
Graphite front bumper brace BD11
YOK-B11-001GA
entspricht: B11-001G
CHF 27.90
Auf Lager
+ −
Graphite upper deck BD11
YOK-B11-003A
entspricht: B11-003
CHF 32.90
Auf Lager
+ −
Graphite front stiffener plate BD11
YOK-B11-003SPA
entspricht: B11-003SP
CHF 17.90
Auf Lager
+ −
Suspension parts set BD11
YOK-B11-008A
entspricht: B11-008
CHF 9.90
Auf Lager
+ −
Front suspension arm pin holders BD11
YOK-B11-008FHA
entspricht: B11-008FH
CHF 11.90
Auf Lager
+ −
Graphite front lower suspension arms (right) BD11
YOK-B11-008FRA
entspricht: B11-008FR
CHF 36.90
Auf Lager
+ −
Rear suspension arm pin holders BD11
YOK-B11-008RHA
entspricht: B11-008RH
CHF 11.90
Auf Lager
+ −
Front bones for double-jointed universal BD11
YOK-B11-010BWA
entspricht: B11-010BW
CHF 11.90
Auf Lager
+ −
Aluminum rear lower bulkhead (A) BD11
YOK-B11-32RLAA
entspricht: B11-32RLA
CHF 36.90
Auf Lager
+ −
Aluminum rear lower bulkhead (B) BD11
YOK-B11-32RLBA
entspricht: B11-32RLB
CHF 36.90
Auf Lager
+ −
Aluminum rear upper bulkhead (A) BD11
YOK-B11-32UAA
entspricht: B11-32UA
CHF 32.90
Auf Lager
+ −
Aluminum rear upper bulkhead (B) BD11
YOK-B11-32UBA
entspricht: B11-32UB
CHF 32.90
Auf Lager
+ −
O-ring for stabilizer wire (4 pieces) BD11
YOK-B11-412OA
entspricht: B11-412O
CHF 3.50
Auf Lager
+ −
Front stabiliser wire (F 1.1 mm) BD11
YOK-B11-412F1A
entspricht: B11-412F1
CHF 8.90
Auf Lager
+ −
Front stabiliser wire (F1.2 mm) BD11
YOK-B11-412F2A
entspricht: B11-412F2
CHF 8.90
Auf Lager
+ −
Front stabiliser wire (F1.3 mm) BD11
YOK-B11-412F3A
entspricht: B11-412F3
CHF 8.90
Auf Lager
+ −
Aluminium stabiliser mount (A) BD11
YOK-B11-412MAA
entspricht: B11-412MA
CHF 11.90
Auf Lager
+ −
Aluminium stabiliser mount (B) BD11
YOK-B11-412MBA
entspricht: B11-412MB
CHF 11.90
Auf Lager
+ −
Stabiliser wire (F1.1 mm) BD11
YOK-B11-412R1A
entspricht: B11-412R1
CHF 8.90
Auf Lager
+ −
Stabiliser wire (F1.2 mm) BD11
YOK-B11-412R2A
entspricht: B11-412R2
CHF 8.90
Auf Lager
+ −
Stabiliser wire (F1.3 mm) BD11
YOK-B11-412R3A
entspricht: B11-412R3
CHF 8.90
Auf Lager
+ −
F5mm suspension ball (4 pieces) BD11
YOK-B11-B50A
entspricht: B11-B50
CHF 8.90
Auf Lager
+ −
RTC steering block arm plate BD11
YOK-B11-RTC-5A
entspricht: B11-RTC-5
CHF 11.90
Auf Lager
+ −
Shock adjust nut / O-ring (2 pieces) BD11
YOK-B11-S4CA
entspricht: B11-S4C
CHF 12.90
Auf Lager
+ −
Optional parts set for BD11 Upgrade 2
YOK-B11-OP2A
entspricht: B11-OP2
CHF 32.90
Auf Lager
+ −
Graphite molded Front sus-arm for YZ-4SF2
YOK-S4-008F2GA
entspricht: S4-008F2G
CHF 15.90
Auf Lager
+ −
Graphite steering block plate for BD10 / 9 RTC
YOK-B10-RTC-5A
entspricht: B10-RTC-5
CHF 10.90
Auf Lager
+ −
Stabiliser Wire BD11 front 1.4mm
YOK-B11-412F4A
F1.4mm is added as a variation of the sway bar wire for BD11. This wire is one rank stiffer than the previous lineup and is mainly used to limit roll on high-grip surfaces. Compared to BD10, BD11 has a lower lever ratio and is more compatible with softer springs. However, on...
CHF 9.90
Auf Lager
+ −
Stabiliser wire BD11 hinten 1.4mm
YOK-B11-412R4A
CHF 9.90
Auf Lager
+ −
Rear short "X30" shock body for YZ-2DTM3 / CAL3
YOK-S4-S4MA
A shock body that can be used on the rear of the YZ-2DTM3 / CAL3 and the front of the YZ-2T. 1 bottle included.
CHF 14.50
Auf Lager
+ −
Body Mount Patch 6x0.5mm
YOK-ZR-BMP6B
entspricht: ZR-BMP6A
CHF 6.90
Auf Lager
+ −
Receiver Capacitor (non-polarized)
YOK-BL-RRCP
This capacitor is connected to the BEC channel of the receiver to reduce noise and stabilize the servo current. When a large load is placed on the servo during driving, the capacitor can momentarily supplement power to stabilize the servo's operation. Since it is non-polarized, it...
CHF 17.90
Auf Lager
+ −
Big Bore Stossdämpfer Diaphragms 4stk. silicon
YOK-YS-8DS
CHF 4.90
Auf Lager
+ −
Progressive Federn 1.80 bis 2.10 20mm
YOK-B10-SSP18
This new spring matches the BD11 with a lower lever ratio than before. The overall setting is softer, making it a perfect match for the BD11's long suspension arms. You can find a good balance by choosing from this lineup for both front and rear. The progressive type spring has a pitch change...
CHF 12.90
Auf Lager
+ −
Progressive Federn BD11 1.90-2.20 20mm
YOK-B10-SSP19
This new spring matches the BD11 with a lower lever ratio than before. The overall setting is softer, making it a perfect match for the BD11's long suspension arms. You can find a good balance by choosing from this lineup for both front and rear. The progressive type spring has a pitch change...
CHF 12.90
Auf Lager
+ −
Progressive Federn BD11 2.10 bis 2.40 20mm
YOK-B10-SSP21
CHF 12.90
Auf Lager
+ −
Yokomo Factory Jacke XL
YOK-ZC-J27XLA
A windproof jacket with the Yokomo Racing Factory logo on the chest and back. Light nylon fabric, perfect for changing seasons. It has a slightly larger size.
CHF 37.90
Yokomo Factory Jacke L
YOK-ZC-J27LA
entspricht: ZC-J27L
CHF 37.90
Auf Lager
+ −
Rear hub carrier link mount für S4-415RS
YOK-S4-415RLA
entspricht: S4-415RL
CHF 14.90
Auf Lager
+ −
High traction rear hub carrier weight
YOK-Y2-415RWA
A steel weight that can be attached directly to the rear hub carrier of the YD-2 series to increase rear traction. It is possible to effectively increase the rear grip by increasing the unsprung weight that directly applies the load to the tire without passing through a damper. The weight is...
CHF 32.90
Auf Lager
+ −
Rear short shock shaft for YZ-2DTM3/CAL3
YOK-S4-S2MA
entspricht: S4-S2M
CHF 9.50
Auf Lager
+ −
Kategorien
Zubehör und Ersatzteile
Antriebs-Set
Dekor-Material
Ersatzteile
Karosserie
Karosserie Zubehör
LKW Zubehör
Motor
Rad und Reifen
Schablonen (Paint Masks)
Tuning
+6Mehr
RC Auto
RC Motorrad
RC Baumaschinen und Traktoren
RC LKW
RC Panzer
Filter
Verfügbarkeit
Verfügbar beim Lieferanten
Hersteller (1)
    Alle zeigen (263)
Passend zu...
    Alle zeigen (90)
Abmessungen
Auswahlhilfe
    Alle zeigen (29)
Material
Preis
CHF
–
CHF
  • CHF 1.5
  • CHF 304
Reifen/Rad-Typ
Servo-Typ
Verwendung
Massstab
    Alle zeigen (19)
Motor / Antrieb
Einsatz
Anspruch
Lackierung
Fertigungsgrad
Marke
    Alle zeigen (67)
Betriebsspannung
Zurücksetzen (reset)
Portofreie Lieferung

Online-Bestellungen portofrei ab CHF 80.-

Bestellung auf Rechnung

Einfach auf Rechnung bestellen.

Schnelle Abwicklung

Vor 16.00 Uhr bestellt, Versand per A-Post gleichentags