ERSATZTEIL-FINDER

Yokomo

Ordnen nach:
Empfohlen
24
Progressive front shock spring 2.50-3.00
YOK-B10-SSP25A
By changing the pitch of the winding, it is a progressive spring that can suppress excessive roll while giving initial softness. It is mainly used for the front suspension of 4WD touring cars, and it is possible to improve the stability of steering when driving in a layout with a high...
CHF12.50
Auf Lager  
+ −
72T 3hole Spur gear (Slipper/Direct)
YOK-Z2-SG72SDA
entspricht: Z2-SG72SD
CHF6.90
Auf Lager  
+ −
69T 3hole Spur gear (Slipper/Direct)
YOK-Z2-SG69SDA
entspricht: Z2-SG69SDA
CHF6.90
Auf Lager  
+ −
Racing Tool 2.0mm Allen Driver black
YOK-YT-20RTBA
entspricht: YT-20RTB
CHF6.90
Auf Lager  
+ −
f10×f15mm Ball Bearing
YOK-BB-1510A
entspricht: BB-1510
CHF8.50
Auf Lager  
+ −
Inner Sponge
YOK-BM-T16A
entspricht: BM-T16
CHF7.10
Auf Lager  
+ −
Aluminum Wing Stay(Low)Black for Drift
YOK-D-057LA
entspricht: D-057L
CHF12.90
Auf Lager  
+ −
Tire Mounting Tape for DRA/DRC Tire
YOK-ZR-DRTA
entspricht: ZR-DRT
CHF4.90
Auf Lager  
+ −
Rear upper arm mount / roll bar holder / gearbox
YOK-Z2-300R31A
Rear upper arm mount / roll bar holder / gearbox support for YZ-2 DTM3.1 / CAL3.1
CHF12.90
Auf Lager  
+ −
Aluminum front lower suspension mount for YZ-2DTM3
YOK-Z2-300FLAA
YZ-2DTM3.1 Standard parts aluminum front lower suspension mount. By swapping the front and back, the height of the suspin can be changed by 1 mm, and the roll center can be adjusted.
CHF29.50
Auf Lager  
+ −
Integrated lightweight bulkhead for YD-2 black
YOK-Y2-302DLA
This is a front integrated bulkhead made of aluminum that can be used commonly with the YD-2 series. Of course, it is available in three anodized colors: black, red and purple. As with the previous parts, this part can greatly increase the strength of the front end, but it...
CHF52.90
Nicht auf Lager
Body Mount Patch (5mm)
YOK-ZR-BMP5B
It is a patch that is attached to the back side of the body of the body mount hole to reinforce the mount hole and protect the paint. For body posts with a diameter of 5 mm.
CHF3.90
Auf Lager  
+ −
Front steering block for YD-2 series
YOK-Y2-415S2A
Resin steering block for RWD drift car YD-2 series. It has been updated for the new short suspension arm, and by installing the steering stopper in the tie rod mounting hole closest to the axle, the optimum turning angle can be obtained.
CHF7.90
Auf Lager  
+ −
SLF Aluminum Big Bore shock set (Red) for YD-2
YOK-Y2SBBSR
Super low friction aluminum big bore shock set for YD-2. The cylinder diameter is wider than the conventional shock, and the shock length is also newly designed for drifting. The maximum capacity for on-road shocks enhances the sense of stability. The cylinder is also treated with Kashima Coat...
CHF89.90
Nicht auf Lager
High Grade O-ring for Shock 8stk.
YOK-YS-7HGCA
(oil resistant / with poly slider / 8 pcs) This new type of O-ring provides the best performance as an oil seal for damper shafts. The soft material allows the shock shaft to slide easily, and the extremely oil-resistant silicon rubber material allows the O-ring to maintain its shape...
CHF9.90
Auf Lager  
+ −
Aluminum upper deck adapter for YD-2ZX (rear)
YOK-Y2-003ZARA
entspricht: Y2-003ZAR
CHF15.90
Auf Lager  
+ −
Aluminum Servo Mount for YD-2ZX (Purple)
YOK-Y2-203ZPA
Aluminum servo mount for YD-2ZX. It is compatible with low profile servos and has a height of approximately 17 mm. The color is purple and comes in 2 pieces.
CHF32.50
Auf Lager  
+ −
Special motor mount for YD-2Z series (purple)
YOK-Y2-304ZSPA
Special motor mount for YD-2Z series. The aluminum heat sink shape has a high cooling effect and efficiently cools the motor during drift driving, which tends to heat up. By rotating around the top shaft, the YD-2Z can select the motor position from 13 places depending on the chassis...
CHF34.90
Auf Lager  
+ −
PULLEY FRONT (ONE-WAY - MR-4TC BD)
Z-BD-643
CHF5.00
Auf Lager bei Lieferant  
Externes Lager. Lieferung in ca. 3 Werktagen.  
+ −
KUGEL ALU WORKS'95 8ST
ZC0401L
CHF14.00
Auf Lager bei Lieferant  
Externes Lager. Lieferung in ca. 3 Werktagen.  
+ −
Graphite upper deck BD11
YOK-B11-003A
entspricht: B11-003
CHF32.90
Auf Lager  
+ −
Graphite front stiffener plate BD11
YOK-B11-003SPA
entspricht: B11-003SP
CHF17.90
Auf Lager  
+ −
Suspension parts set BD11
YOK-B11-008A
entspricht: B11-008
CHF9.90
Auf Lager  
+ −
Front suspension arm pin holders BD11
YOK-B11-008FHA
entspricht: B11-008FH
CHF11.90
Auf Lager  
+ −
Verfügbarkeit
Verfügbar beim Lieferanten
Abmessungen
Auswahlhilfe
Material
Preis

CHF  –  CHF

  • ‎CHF1.5
  • ‎CHF949
Reifen/Rad-Typ
Servo-Typ
Verwendung
Massstab
Motor / Antrieb
Einsatz
Anspruch
Lackierung
Fertigungsgrad
Max. Geschwindigkeit
Marke
Betriebsspannung
Zurücksetzen (reset)