Français (CH)
ERSATZTEIL-FINDER

Yokomo

Trier par:
Recommandé
Montrer:
48
Aluminum turnbuckle set for MD1.0
YOK-MD-TBS
This set converts the turnbuckles used in the MD series upper arms and tie rods to aluminum. 20mm/27mm/33mm turnbuckles are included, to reduce weight and improve suspension response.
CHF 21.50
En stock
+ −
YOKOMO Parts Case 86X103X34mm
YOK-YC-13
new lineup of parts cases with the Yokomo logo has been added to the series. The three new cases are suitable for storing relatively small parts, and feature a large number of movable dividers that can be positioned in a variety of ways. The body is made of polypropylene, which is...
CHF 8.90
En stock
+ −
YOKOMO Parts Case 205X145X40mm
YOK-YC-14
A new lineup of parts cases with the Yokomo logo has been added to the series. The three new cases are suitable for storing relatively small parts, and feature a large number of movable dividers that can be positioned in a variety of ways. The body is made of polypropylene, which is...
CHF 13.90
En stock
+ −
BD-919/BD10/BD10LC AXON super hub axle pin/"O" rin
YOK-B10-WHAS2A
entspricht: B10-WHAS2
CHF 4.50
En stock
+ −
Graphite front body mount stay for MD1.0
YOK-MD-016MG
CHF 34.90
En stock
+ −
Alu high mount Battery Post (R)
YOK-Y2-118RL
CHF 23.90
En stock
+ −
Alu hight mount battery post (F)
YOK-Y2-118FL
CHF 16.90
En stock
+ −
Drift LTS Front Spring 0.9x45x8.5turns
YOK-D-186
CHF 11.50
En stock
+ −
Drift LTS Front Spring 1.0×48mm×9.0turns
YOK-D-187
CHF 11.90
En stock
+ −
Drift LTS Rear Spring 1.0×48mm×10.0turns
YOK-D-188
CHF 11.90
En stock
+ −
F/R body mount for BD9/10/11 (hard)
YOK-B11-016H
CHF 9.90
En stock
+ −
Titanium Lower Shock Mount for BD11
YOK-B11-S9T
CHF 12.90
En stock
+ −
Graphite front upper deck BD12
YOK-B12-003F
CHF 24.90
En stock
+ −
Graphite rear upper deck BD12
YOK-B12-003R
CHF 24.90
En stock
+ −
Graphite center stiffener for BD12
YOK-B12-302CS
CHF 19.90
En stock
+ −
Brass center stiffener for BD12
YOK-B12-302CSB
CHF 35.90
En stock
+ −
Graphite molded front steering hub carrier BD12
YOK-B12-413G
CHF 17.90
En stock
+ −
Shock shaft guide for BD12
YOK-B12-S2B
CHF 13.50
En stock
+ −
Aluminum spring cup for BD12 (bearing specificatio
YOK-B12-S3S
CHF 10.50
En stock
+ −
Aluminum shock adjust nut/O ring for BD12
YOK-B12-S4AJ
CHF 10.50
En stock
+ −
Aluminum upper shock cap nut for BD12
YOK-B12-S4C1
CHF 9.70
En stock
+ −
Aluminum shock cylinder for BD12
YOK-B12-S4S
CHF 24.90
En stock
+ −
Shock shaft for BD12
YOK-B12-S5S
CHF 7.50
En stock
+ −
Shock cap/shock end for BD12
YOK-B12-S6
CHF 7.50
En stock
+ −
AXON TCS 90T spur gear (hard)
YOK-SG-A6490
CHF 7.50
En stock
+ −
Graphite rear upper deck 1.5mm für BD12
YOK-B12-003RS
CHF 23.90
En stock
+ −
Graphite rear stiffener plate für BD11/BD12
YOK-B12-003RSP
CHF 21.00
En stock
+ −
Belt tension adjustment cam for BD10/9 (2 pieces m
YOK-B10-BTCBA
entspricht: B10-BTCB
CHF 19.90
En stock
+ −
Chassis Schutzfolie 200x390mm
YOK-ZC-CPS
Protective sheet that is attached to the back of the chassis to protect the chassis from road surface interference.The slightly thicker material and stronger adhesive surface ensure a firm bond. The price is reasonable for periodic replacement. It can be used for speed category,...
CHF 3.90
En stock
+ −
Front Stabi Draht 0.9mm BD11/BD12
YOK-B11-412F09A
Sway bar for BD12/11 series touring car chassis. With 0.9mm and 1.0mm wire diameter settings, which are thinner than the previous lineup, these bars are mainly effective when driving on outdoor asphalt, using roll to increase grip. Please use as setting parts.
CHF 8.90
En stock
+ −
Front Stabidraht 1.0mm BD11/BD12
YOK-B11-412F0A
Sway bar for BD12/11 series touring car chassis. With 0.9mm and 1.0mm wire diameter settings, which are thinner than the previous lineup, these bars are mainly effective when driving on outdoor asphalt, using roll to increase grip. Please use as setting parts.
CHF 8.90
En stock
+ −
Stabidraht hinten 0.9mm BD11/BD12
YOK-B11-412R09A
Sway bar for BD12/11 series touring car chassis. With 0.9mm and 1.0mm wire diameter settings, which are thinner than the previous lineup, these bars are mainly effective when driving on outdoor asphalt, using roll to increase grip. Please use as setting parts.
CHF 8.90
En stock
+ −
Stabidraht hinten 1mm BD11/BD12
YOK-B11-412R0A
Sway bar for BD12/11 series touring car chassis. With 0.9mm and 1.0mm wire diameter settings, which are thinner than the previous lineup, these bars are mainly effective when driving on outdoor asphalt, using roll to increase grip. Please use as setting parts.
CHF 8.90
En stock
+ −
Aluminum motor mount for BD10F
YOK-B10-302MFA
Aluminum motor mount for BD10F. Backlash can be adjusted by sliding the joint with the center mount.
CHF 22.90
En stock
+ −
Aluminum clamp type servo horn for YD-2ZX
YOK-Y2-204Z26A
Aluminum servo horn for YD-2ZX. It has a shape that matches the mounting method where the servo is placed directly on the main chassis, and is a type that is fixed with a clamp through an adapter that matches the servos of each company.
CHF 21.00
En stock
+ −
Alum. S2 Chassis weight (9g) for SO2.0
YOK-Z2-002WA
CHF 16.90
En stock
+ −
Steel S2 Chassis weight (26g) for SO2.0
YOK-Z2-002WS
CHF 15.90
En stock
+ −
Alum Adjustable Front Axle for SO2.0
YOK-Z2-010AFA
CHF 16.90
En stock
+ −
Wide front wing for SO series
YOK-Z2-107FW2
CHF 8.90
En stock
+ −
Graphite Steering Block Plate DOT1for SO2.0
YOK-Z2-415S21
CHF 11.50
En stock
+ −
Steering Block L/R (Hard) for SO2.0
YOK-Z2-415S2H
CHF 6.90
En stock
+ −
Steering Block L/R (Graph) for SO2.0(2pcs.)
YOK-Z2-415S2G
CHF 11.90
En stock
+ −
M2 x 3mm flat head socket screw (4 pieces)
YOK-ZC-F23
CHF 2.90
En stock
+ −
Gokuraku off-road wing (straight)
YOK-ZS-GWBS
CHF 14.90
En stock
+ −
Graphite shock tower für RS1.0 vorne
YOK-RS-017G
CHF 14.90
En stock
+ −
Graphite shock tower für RS1.0 hinten
YOK-RS-018G
CHF 22.90
En stock
+ −
Alu Brush Motor Adapter für RS1.0
YOK-RS-302AD
CHF 8.90
En stock
+ −
RP Ultra Shock Oil #27.5 (Light Yellow)
YOK-RP-113275
CHF 8.90
En stock
+ −
Verfügbarkeit
Verfügbar beim Lieferanten
Abmessungen
Auswahlhilfe
Material
Prix
CHF
–
CHF
  • CHF 1.5
  • CHF 849
Reifen/Rad-Typ
Servo-Typ
Verwendung
Massstab
Motor / Antrieb
Einsatz
Anspruch
Lackierung
Fertigungsgrad
Max. Geschwindigkeit
Marke
Betriebsspannung