RC4WD Sledge Hammer Heavy Haul Dump Truck

Specifications:

• Hard Plastic European Style Front Cab
• Full Metal 2 Speed Transmission (Planetary Gears)
• Transfer Case (Billet Aluminum)
• Scale Fuel Tank (Billet Aluminum)
• Super Scaled Leaf Spring Suspension Setup
• Scale Rims (Billet Aluminum)
• Remote Lockable Rear Axle (Locking Differential)
• Full Metal Front and Rear Axle Housing
• Steel Scale Drive Shaft
• Realistic Front Cab Latch
• Retractable Steel Ladder
• Molded Functional Fuel Tank
• Fully Controllable Truck Bed
• Automatic Trailer Gate (Do Not Attempt to Open by Hand)
• Rear Light Guard (Protects Against Rocks)
• Scale Light Buckets (Fits 3-5mm LED)
• Recommended Payload: 15kg / 33lbs
• Maximum Load: 25kg / 55lbs
• LiPo Cutoff
• Fully Painted
• Scale Wheel/Tire
• Cylinder Maximum Thrust: 109kg / 231lbs
• Brushed Driven Motor
• 300KV Brushless Motor-Driven Micro Hydraulic Pump
• Length: 26.5in / 674mm
• Width: 8.93in / 227mm
• Height: 10.7in / 273mm (Including Antenna)
• Weight: 10kg / 22lbs
• Axle Gear Ratio: 2.6:1
• Transfer Case Gear Ratio: 1:1
• First Gear 1:64, Second Gear 1:16 (Transmission)
• Basic 6 Channel 2.4Ghz Radio

What's Included:

• 1x 1/14 6x6 Sledge Hammer Heavy Haul Off-Road Hydraulic RTR Dump Truck

Required Parts:

• 5000mAh 11.1V 50C 3S1P LiPo Battery Pack with XT60 Plug (Battery size must be no bigger than 140mm in length, 45mm in width, and 25mm in height)
• Compatible Battery Charger
• 4x AA Batteries for Radio (Z-S1718)
• Chevron AW ISO 32 Hydraulic Oil 14oz (Z-X0042)

Notes:

• Must turn on the transmitter before starting the ESC.
• ESC Supports XT60 Connector
• While some components may come assembled, we recommend checking the hardware and screws are all properly secure, especially after shipping. As an option, you may want to apply thread lock to some of the installed hardware.
• Use good quality hex drivers to avoid stripping screw heads.
• Use thread lock when putting metal screws into metal parts.
• Use threadlock sparingly.
• Do not over tighten screws, otherwise, you may strip the thread.
• Do not use more than 3S battery. (11.1 volt(s))
• This product is for experienced R/C users. Not recommended if you just started with R/C.
• This Product Is Professionally Pre-assembled
• Manufactured by JDCustoms 30 Days Limited Warranty