Deutsch (CH)
ERSATZTEIL-FINDER

Yokomo

Empfohlen
24 Pro Seite
RTC steering block arm plate BD11
YOK-B11-RTC-5A
entspricht: B11-RTC-5
CHF 11.90
Auf Lager  
+ −
Shock shaft guide (4 pieces) BD11
YOK-B11-S2BA
entspricht: B11-S2B
CHF 11.90
Auf Lager  
+ −
Shock adjust nut / O-ring (2 pieces) BD11
YOK-B11-S4CA
entspricht: B11-S4C
CHF 12.90
Auf Lager  
+ −
Optional parts set for BD11 Upgrade 2
YOK-B11-OP2A
entspricht: B11-OP2
CHF 32.90
Auf Lager  
+ −
Graphite molded Front sus-arm for YZ-4SF2
YOK-S4-008F2GA
entspricht: S4-008F2G
CHF 15.90
Auf Lager  
+ −
Graphite steering block plate for BD10 / 9 RTC
YOK-B10-RTC-5A
entspricht: B10-RTC-5
CHF 10.90
Auf Lager  
+ −
Stabiliser Wire BD11 front 1.4mm
YOK-B11-412F4A
F1.4mm is added as a variation of the sway bar wire for BD11. This wire is one rank stiffer than the previous lineup and is mainly used to limit roll on high-grip surfaces. Compared to BD10, BD11 has a lower lever ratio and is more compatible with softer springs. However, on...
CHF 9.90
Auf Lager  
+ −
Stabiliser wire BD11 hinten 1.4mm
YOK-B11-412R4A
CHF 9.90
Auf Lager  
+ −
Rear short "X30" shock body for YZ-2DTM3 / CAL3
YOK-S4-S4MA
A shock body that can be used on the rear of the YZ-2DTM3 / CAL3 and the front of the YZ-2T. 1 bottle included.
CHF 14.50
Auf Lager  
+ −
Body Mount Patch 6x0.5mm
YOK-ZR-BMP6B
entspricht: ZR-BMP6A
CHF 6.90
Auf Lager  
+ −
Programmierbox für RPX3 ESC
YOK-BL-R26P3
A dedicated programmer is required to change the RPX3 program. We plan to distribute firmware to update the old programmer (BL-R26P), but you will need to revert to the old firmware (to be distributed) to change the program of the old ESC after the update.
CHF 38.90
Nicht auf Lager
Receiver Capacitor (non-polarized)
YOK-BL-RRCP
This capacitor is connected to the BEC channel of the receiver to reduce noise and stabilize the servo current. When a large load is placed on the servo during driving, the capacitor can momentarily supplement power to stabilize the servo's operation. Since it is non-polarized, it...
CHF 17.90
Auf Lager  
+ −
Big Bore Stossdämpfer Diaphragms 4stk. silicon
YOK-YS-8DS
CHF 4.90
Auf Lager  
+ −
High Grade O-Ring (oil resistant blue, 8stk.)
YOK-YS-7HG2
CHF 8.90
Auf Lager  
+ −
Progressive Federn 1.80 bis 2.10 20mm
YOK-B10-SSP18
This new spring matches the BD11 with a lower lever ratio than before. The overall setting is softer, making it a perfect match for the BD11's long suspension arms. You can find a good balance by choosing from this lineup for both front and rear. The progressive type spring has a pitch change...
CHF 12.90
Auf Lager  
+ −
Progressive Federn BD11 1.90-2.20 20mm
YOK-B10-SSP19
This new spring matches the BD11 with a lower lever ratio than before. The overall setting is softer, making it a perfect match for the BD11's long suspension arms. You can find a good balance by choosing from this lineup for both front and rear. The progressive type spring has a pitch change...
CHF 12.90
Auf Lager  
+ −
Progressive Federn BD11 2.10 bis 2.40 20mm
YOK-B10-SSP21
CHF 12.90
Auf Lager  
+ −
SCR-BL Fahrtenregler für brushed Motoren
YOK-SCR-BL
AKTION SOLANGE VORRAT This is a speed controller dedicated to brush motors, which is very popular among beginners and intermediate players. This model was also used in Yokomo's pre-assembled competition off-road car, and it is equipped with a large heat sink, making it a tough performance...
CHF 35.00
Auf Lager  
+ −
Yokomo Factory Jacke XL
YOK-ZC-J27XLA
A windproof jacket with the Yokomo Racing Factory logo on the chest and back. Light nylon fabric, perfect for changing seasons. It has a slightly larger size.
CHF 37.90
Nicht auf Lager
Yokomo Factory Jacke L
YOK-ZC-J27LA
entspricht: ZC-J27L
CHF 37.90
Auf Lager  
+ −
Rear hub carrier link mount für S4-415RS
YOK-S4-415RLA
entspricht: S4-415RL
CHF 14.90
Auf Lager  
+ −
High traction rear hub carrier weight
YOK-Y2-415RWA
A steel weight that can be attached directly to the rear hub carrier of the YD-2 series to increase rear traction. It is possible to effectively increase the rear grip by increasing the unsprung weight that directly applies the load to the tire without passing through a damper. The weight is...
CHF 32.90
Auf Lager  
+ −
Rear short shock shaft for YZ-2DTM3/CAL3
YOK-S4-S2MA
entspricht: S4-S2M
CHF 9.50
Auf Lager  
+ −
Inline Battery holder conversion für MD1.0
YOK-MD-CONV
This is a battery holder conversion to change the battery mounting of MD1.0 to inline mounting. When the car has a certain degree of grip, mounting the battery inline (in the front-back direction of the chassis) suppresses chassis roll, enabling sharper movement when transitioning to an...
CHF 43.90
Auf Lager  
+ −
Verfügbarkeit
Verfügbar beim Lieferanten
Abmessungen
Auswahlhilfe
Material
Preis
CHF
–
CHF
  • CHF 1.5
  • CHF 849
Reifen/Rad-Typ
Servo-Typ
Verwendung
Massstab
Motor / Antrieb
Einsatz
Anspruch
Lackierung
Fertigungsgrad
Max. Geschwindigkeit
Marke
Betriebsspannung